第三族金属氧化物离子对二氧化碳转化的红外光谱研究

本文利用红外光解离光谱研究了第三族金属氧化物离子对二氧化碳分子的转化机制. 研究表明，对于[ScO(CO₂)_n]⁺体系，在n≤4时，形成了溶剂化结构；在n=5时，形成了碳酸盐结构，实现了二氧化碳的转化. 对于[YO(CO₂)_n]⁺体系，需要4个二氧化碳分子就可以实现二氧化碳的转化. 而在[YO(CO₂)_n]⁺体系中，只发现了溶剂化结构，没有观察到碳酸盐结构. 理论计算表明，[YO(CO₂)_n]⁺体系拥有最小的溶剂化结构向碳酸盐结构转化能垒，[LaO(CO₂)_n]⁺体系拥有最大的溶剂化结构向碳酸盐结构转化能垒. 本文从分子水平揭示了不同金属氧化物离子对二氧化碳分子转化的影响规律.     

基于相移偏折法的高反射表面面形测量技术

利用单相机所采集的图像实现了对光滑高反射表面面形的直接检测.首先利用相机获取参考平面在标准平面镜中的镜像,然后通过参考平面上的点与归一化成像平面上图像点之间的密集折返对应关系,求得待测镜面的深度距离,从而实现对高反射表面面形的测量.通过光线追迹将该测量过程转化为求解物空间中关于两对应光线束之间的相交问题.以相位为载体获取面形梯度分布,求得该表面的法向量场,并求解相应的反射光线束.通过光线追迹对该光线束与相应入射光线束求“交点”检测高反射表面.对标准平面镜进行实验检测,测量得到的面形平面度为0.19 mm.采用传统方法与本文所提方法对汽车后视镜进行检测,所得检测结果对应点之间的平均距离为0.15 mm,验证了本文方法检测镜面面形的有效性.     

光子晶体光纤温度压力传感器

提出了一种在高温环境下同时测量温度和气压的光子晶体光纤温度压力传感器.在普通单模光纤和光子晶体光纤之间熔接一段空心光纤构成干涉结构.空心光纤段构成非本征法布里-珀罗干涉仪,利用光子晶体光纤的微孔与外界相通,通过气体折射率变化来测量环境中的气压变化;光子晶体光纤段构成本征法布里-珀罗干涉仪,利用热膨胀效应和热光效应来测量环境中的温度.传感器的解调通过自制的白光干涉解调仪实现,实验通过测量腔长得到被测环境的温度和气压.在不同温度和气压环境下,对腔长分别为306μm和1535μm的温度压力光纤传感器进行连续测量.实验结果表明,传感器能够在28~800℃的温度下和0~10 MPa的气压下稳定工作,测量范围内温度灵敏度可达17.4 nm/℃,压力灵敏度随温度增加而降低,在28℃时可达1460.5 nm/MPa.     

考虑制动力影响的大型客车舒适性分析

利用有限元法和动力平衡原理,建立了具有层间接触的沥青路面和13个自由度的大型客车人体三维模型。以不平顺作为激励,随机模拟车流分布,在不同制动情况下,从时域和频域两方面分析人-车-路耦合振动下车辆和人体的动力响应。时域分析采用客观评价标准和主观烦恼率相结合的方法,频域分析考虑人体共振、人的心理和生理因素。结果表明:随着制动力增大,人体的竖向加速度幅值不变,俯仰、侧倾加速度幅值都增大,但是俯仰加速度增幅远大于侧倾加速度的情况,人的舒适性变差,烦恼率增高;在紧急制动时,主频段对人体共振、心理和生理产生的影响很小,但是次主频段与人体某些器官固有频段重合,对人体共振、心理和生理产生的影响是不容忽视的。     

油-气-水三相流超声传感器持气率测量*

为探索油-气-水三相流持气率测量难题,该文开展了脉冲透射式超声传感器持气率测量动态实验研究。首先,利用超声传感器与光纤传感器组合,测取了油-气-水三相流中段塞流、混状流、泡状流的响应信号;其次,提取了超声脉冲信号的最大值序列来反映不同流型时超声传感器响应特性,同时,借助双头光纤传感器与相关测速法,计算得到了流体中气泡弦长序列;最后,结合流型与泡径信息,利用超声传感器测量了不同流型下持气率,并分析了不同流型持气率预测的误差来源,为其他油-气-水三相流持气率测量传感器设计提供了借鉴。     

On-chip multiphoton Greenberger–Horne–Zeilinger state based on integrated frequency combs

One of the most important multipartite entangled states, Greenberger–Horne–Zeilinger state (GHZ), serves as a fundamental resource for quantum foundation test, quantum communication and quantum computation. To increase the number of entangled particles, significant experimental efforts should been invested due to the complexity of optical setup and the difficulty in maintaining the coherence condition for high-fidelity GHZ state. Here, we propose an ultra-integrated scalable on-chip GHZ state generation scheme based on frequency combs. By designing several microrings pumped by different lasers, multiple partially overlapped quantum frequency combs are generated to supply as the basis for on-chip polarization-encoded GHZ state with each qubit occupying a certain spectral mode. Both even and odd numbers of GHZ states can be engineered with constant small number of integrated components and easily scaled up on the same chip by only adjusting one of the pump wavelengths. In addition, we give the on-chip design of projection measurement for characterizing GHZ states and show the reconfigurability of the state. Our proposal is rather simple and feasible within the existing fabrication technologies and we believe it will boost the development of multiphoton technologies.     

On the nature of phase separation of polymer solutions at high extension rates

Experiments with stretching moderately concentrated polymer solutions have been carried out. Model experiments were carried out for poly(acrylonitrile) solutions in dimethyl siloxane. Just the choice of concentrated solutions allowed for a clear demonstration of a demixing effect with the formation of two separate phases—an oriented polymer fiber and solvent drops sitting on its surface. An original experimental device for following all subsequent stages in the demixing process was built. It combined two light beams, one transverse to the fiber and a second directed along (inside) the fiber, the latter played the role of an optical line. This gives a unique opportunity to observe processes occurring inside a fiber. The process of demixing starts from the volume phase separation across the whole cross section of a fiber at some critical deformation and the propagation of the front of demixing along the fiber. Then a solvent cylindrical skin appears which transforms into a system of separate droplets. New experimental data are discussed based on a comparison of the current different points of view on the phenomenon of deformation‐induced phase separation: thermodynamic shift of the equilibrium phase transition temperature, growth of stress‐induced concentration fluctuations in two‐component fluids, and mechanically pressing a solvent out from a polymer network. The general belief is that a rather specific (so‐called “beads‐on‐a‐string”) structure of a filament is realized in stretching dilute solutions: beads of a polymer solution connected by oriented polymer bridges forming a single object. The situation in stretching moderately concentrated solutions appears quite different: real phase separation was observed. So, the alternative phenomenon to the formation of the “beads‐on‐a‐string” structure has been experimentally proven. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 559–565     

On the low-temperature anomalies of specific heat in disordered carbon nanotubes

The low-temperature behavior of the specific heat in disordered nanotubes strongly depends on structure changes and is not explained by the phonon contribution. Expression for electronic specific heat is carried out taking into account the multiple elastic electron scattering on impurities and structural inhomogeneities of short-range order type. The calculated electronic specific heat depends on diameter of nanotube, concentration of impurities, parameters of short-range order (structural heterogeneity) and describes the peculiarities of low-temperature behavior of specific heat observed in disordered CNT.     

Statistics of polymer capture by a nanopore: A Brownian dynamics simulation study

We investigate the statistics of polymer capture by a nanopore using Brownian dynamics simulations. It is found that when the velocity flux is greater than a critical velocity flux, the capture picture is a random selection process, otherwise it tends to a statistical process governed by energetic considerations. In addition, the chain ends capture probability decreases as the chain length increases and satisfies a power-law scaling of P0(N)~N-0.8.